:	Oct 13, 2004

.

: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands. Raise and support the vehicle.

.

Remove the wheel and tire.

.

Disconnect the anti-lock brake system (ABS) sensor electrical connector.   Release the wiring harness retaining clip.

.

Release the wheel speed sensor from the wheel knuckle.   Release the wiring harness.   Remove the retaining bolt.

.

Remove the wheel speed sensor.   Release the wiring harness from the 4 clips.

.

Make sure the wheel speed sensor location in the wheel knuckle is free of dirt.

.

Install the wheel speed sensor.   Attach the wiring harness to the 4 clips.

.

Secure the wheel speed sensor to the wheel knuckle.   Tighten the bolt to 9 Nm (7 lb.ft).   Attach the wiring harness to the clip.

.

:   Make sure the electrical connector retaining clip is attached to the body wiring harness. Connect the ABS sensor electrical connector.   Attach the wiring harness.

.

If a new wheel speed sensor has been installed, interrogate the ABS system using T4.